Project Coordinated by Customer ServiceExpert Roof Replacement Project Near You on Beaumont Ln
Project Overview
Dr. Roof completed a full roof replacement on Beaumont Ln in Dunwoody, GA to address failing shingles, minor decking rot, and inadequate attic ventilation. The scope removed the old roof, repaired OSB decking, installed new underlayment, upgraded insulation and vents to boost storm resistance, energy efficiency, and curb appeal for a homeowner preparing for Georgia's hot, humid summers and seasonal storms.
Results
The new roof restored a watertight barrier and eliminated active leaks, giving the homeowner long-term protection against heavy rain and high winds common in Dunwoody. GAF Timberline shingles paired with StormGuard and sealed hip and ridge components improved impact and wind resistance while modified bitumen protected low-slope transitions. Updated perlite insulation and added ridge and box vents improved attic ventilation and thermal performance, reducing heat transfer and easing the cooling load. The completed system is eligible for GAF manufacturer warranties and is backed by Dr. Roof’s installation guarantee, delivering both durability and homeowner confidence.
Materials Used
This roof replacement on Beaumont Ln in Dunwoody, GA was completed by Dr. Roof for a single-family residence. Homeowners noted the attention to detail, high-quality materials, and professional craftsmanship throughout the project.
- Shingles: 29.67 sq GAF Timberline HDZ, charcoal
- Underlayment: 3 rolls GAF FeltBuster
- Starter shingles: 3 bundles GAF Pro-Start
- Hip & ridge: 7 bundles GAF Seal-A-Ridge, charcoal
- Storm protection: 2 rolls GAF StormGuard
- Modified bitumen: 3 rolls Liberty Cap Sheet, black
- Base sheet: 2 rolls MA Base 2 sq roll
- Insulation: 16 sheets perlite, 4' × 4' × 1/2"
- Decking repair: 6 OSB boards
- Nails & fasteners: Simplex nails (2 boxes 5 lb 1½"), coil nails (2 boxes 1¼" galvanized), Stinger NailPac (2 boxes)
- Pipe boots: 2 three-in-one with rain collar, black
- Ventilation: 12 Cobra III ridge vents, 2 Lomanco 750 slantback box vents
- Flashing and metal: 1 roll 25' galvanized rolled flashing (24"), step flashing box (2" × 4" × 8" 26ga black), drip edge eaves 18 pcs 10' × 5" × 2" black, drip edge rakes 8 pcs 10' × 4" × 2" black, additional 5 pcs 10' Kirk’s metal
- Sealants and primers: NP1 sealant 2 tubes black, NP1 sealant 1 tube clear, Ultra Karnak 19 (7 tubes), asphalt primer (2 cans)
- Accessories: spray paint 2 cans black