Project Coordinated by Customer ServiceExpert Roof Replacement Project Near You on Glenhaven Dr
Project Overview
On Glenhaven Dr in Decatur, Georgia, Dr. Roof replaced an aging, leak-prone roof with a durable GAF system to boost storm protection, ventilation, and curb appeal. The homeowners wanted long-term reliability against Georgia storms and heat; we removed worn decking, installed upgraded underlayment and ridge ventilation, and fitted high-performance shingles for improved durability and energy performance.
Results
The new roof eliminated active leaks, tightened flashing details, and delivered a clean, cohesive look in charcoal that greatly improved curb appeal. Upgraded ventilation with Cobra III ridge vents reduced attic temperatures and moisture buildup, enhancing energy efficiency and extending shingle life. Workmanship is backed by Dr. Roof’s installation warranty and the materials are supported by GAF’s limited warranty, giving the homeowner confidence against heavy Decatur storms and seasonal weather swings.
Materials Used
This roof replacement on Glenhaven Dr in Decatur, Georgia, was completed by Dr. Roof as a full residential roof replacement project. Homeowners noted the high-quality materials and careful flashing details that improved storm resistance and aesthetics.
- 33 sq GAF Timberline HDZ shingles, Charcoal
- 4 rolls Tri-Built underlayment
- 3 bundles starter shingles
- 5 bundles GAF Seal-A-Ridge, Charcoal
- 1 roll GAF StormGuard
- 18 pcs drip edge (10' × 5" × 2", black @ eaves)
- 8 pcs drip edge (10' × 4" × 2", black @ rakes)
- 2 boxes Stinger NailPac and 2 boxes hand nails (50 lb)
- 3 pipe boots (3" with rain collar, black)
- 21 pcs Cobra III ridge vent
- 1 goose-neck style exhaust vent (7")
- 1 roll 25' galvanized rolled flashing (24" wide)
- 1 box 2" × 4" × 8" 26ga black step flashing
- 1 piece 4" × 4" black headwall flashing
- 3 pcs 5" black counter flashing
- 7 tubes black NP1 and 1 tube clear NP1 for sealant points
- 10 boards 1×6×10 decking and 2 boards 2×4×10 decking replaced where needed
- 2 boards ½" OSB for a custom chimney cricket
- 1 can black spray paint for finish touch-ups